Aaf-international Type W RotoClone Manual de usuario

Type W RotoClone®Wet Centrifugal CollectorInstallation, Operation, and Maintenance InstructionsBetter Air is Our Business®IMPORTANT: Read this manual

RotoClone Size C = Cap ScrewsF = ImpellerClearance8 3/8 - 16 X 1 5/16 - 7/1610 3/8 - 16 X 1 7/16 - 9/1612 3/4 - 10 X 1 9/16 - 11/1614 3/4 - 10 X 1 9/1

115.0 Troubleshooting5.1 Water Entrainment - Excessive discharge of water in the exhaustmay be due to the following:• Incorrect rotation (correct rota

12NOTE 1: Shipping weight does not include motor and drive.NOTE 2: Operating weight includes estimated weight for motor and drive for Arrangements “A”

7.0 StorageTemporary (30 days or less) storage of W RotoClones should beindoors in a controlled atmosphere, free from dirt and moisture.Long term (gre

14Type W RotoClone Parts List:1. Expansion Chamber Assembly2. Impeller Shaft 3. Bearing, Shown on4. Water Cone Assembly 5. Inlet Cone Assembly6. Impel

9.0 Supplements For Optional Features9.1 Food Quality W RotoClones “Food Quality” refers to features on the W RotoClone that make it readily accessibl

Type W RotoClone® 10300 Ormsby Park Place Suite 600Louisville, Kentucky 40223-6169www.aafintl.comCustomer Service 800.477.1214 Fax 800.254.3019AAF has

Table of Contents1.0 Description2.0 Installation2.1 Foundations 2.2 RotoClone Erection (Arrangement A & D) 2.3 Duct Connections (Arrangement A &am

2.0 InstallationThe following instructions should be read carefully before installing the RotoClone.2.1 Foundations Foundations must be true, level, a

RotoClone Erection (Arrangement D) Refer to Arrangement D Erection Diagram - Figure 2. Assemblyshould proceed in the following manner, using gaskets a

52.3 Duct Connections (Arrangement A) Inlet and discharge ducts must be supported from floor, wall, or ceiling, and not by the RotoClone. The joint be

Figure 4 — Piping Diagram, Arrangements A and D2.6A Pressure Switch A switch is supplied with the RotoClone which will stop the RotoClonemotor automat

72.12 Drive Type W RotoClones are belt-driven. Motor, if supplied by others,should be equipped with adjustable slide base. Short center V-belt drive,

4.8 Shaft SealOther than routine greasing of the shaft seal (see 4.1 Lubrication), theshaft seal requires no maintenance. Should the seal fail, replac

94.9 Replacement of Shaft, Impeller or Water Cone Removal of the shaft, impeller, or water cone requires access to the front of the scroll. This is mo