Aaf-international Front Access Housings Manual de usuario

SAAF Front Access Housings with SAAF Cassette Gas Phase Chemical FiltersInstallation, Operation and Maintenance InstructionsBetter Air is Our Bu

3.6.6 Preparing the FAH-202-2P-CG, FAH-201-2P-CG, and FAH-102-2P-HD Housings for Sealing and Locking of the Cassettes:The FAH-202-2P-CG and FAH-201-2P

Step 4: Insert the filter seal locking handle into the locking channel so that the lockinghandle support tab protrudes completely through the hole in

Repeat the process of gas phase cassette installation and sealinguntil all housings are filled with sealed cassettes as shown below.3.7 Prefilter Inst

Repeat the process of prefilter installation until all housings are filledwith latched prefilters as shown below.3.8 Pressure Gauge: It is recommended

5.2 After-filter: If an after-filter has been installed in the system tocollect an initial plume of dust that might be blown from the gas phasechemica

6.1.3 Condensation: Humid air combined with cold surfaces mayresult in condensation of moisture and blinding of both theparticulate and gas phase filt

Better Air is Our Business¤AAF has a policy of continuous product researchand improvement and reserves the right to changedesign and specifications wi

1.2 Packaging and Shipping, Receiving and Inspection, Handlingand Storage1.2.1 Packaging and Shipping: Unless otherwise defined in thepurchase order a

Model FAH-202-2P-MD housing holdsfour (4) MD cassettes.Model FAH-202-2P-HD housing holdstwo (2) HD cassettes. Model FAH-202-2P-CG housing holdstwo (2)

1.4 Product Model DesignationsThe FAH model is designated as follows:FAH - 202 — 2P — MDCopies of the appropriate drawings will have been supplied as

NO WELDING WILL BE REQUIRED.In general, assembly of the filter bank will consist of the following:— Preparation of the installation location— Transpor

FAH-202-2P-MD Entering air face of the housings is shown.Locking handle support tab ships loosewith the Type CG housing.FAH-202-2P-HD FAH-202-2P-CGCa

Each individual FAH is specifically designed to accommodate andsecurely seal AAFs gas phase chemical filter cassettes. Each housingincorporates a uni

3.4.3 Connecting the Front Access Housings: The individualhousings shall be riveted together using the holes provided, asshown in Figure 2. Four (4) r

with your AAF representative to obtain an appropriate product. Also,before blowing down the system, check that it is safe to operate thefan without